收藏本站
AT24C01
Device Operation
CLOCK and DATA TRANSITIONS: The SDA pin is normally pulled high with an exter-
nal device. Data on the SDA pin may change only during SCL low time periods (refer to
Data Validity timing diagram). Data changes during SCL high periods will indicate a start
or stop condition as defined below.
START CONDITION: A high-to-low transition of SDA with SCL high is a start condition
which must precede any other command (refer to Start and Stop Definition timing
diagram).
STOP CONDITION: A low-to-high transition of SDA with SCL high is a stop condition
which terminates all communications. After a read sequence, the stop command will
place the EEPROM in a standby power mode (refer to Start and Stop Definition timing
diagram).
ACKNOWLEDGE: All addresses and data words are serially transmitted to and from
the EEPROM in 8-bit words. Any device on the system bus receiving data (when com-
municating with the EEPROM) must pull the SDA bus low to acknowledge that it has
successfully received each word. This must happen during the ninth clock cycle after
each word received and after all other system devices have freed the SDA bus. The
EEPROM will likewise acknowledge by pulling SDA low after receiving each address or
data word (refer to Acknowledge Response from Receiver timing diagram).
STANDBY MODE: The AT24C01 features a low power standby mode which is enabled:
(a) upon power-up and (b) after the receipt of the STOP bit and the completion of any
internal operations.
MEMORY RESET: After an interruption in protocol, power loss or system reset, any 2-
wire part can be reset by following these steps:
(a) Clock up to 9 cycles, (b) look for SDA high in each cycle while SCL is high and then
(c) create a start condition as SDA is high.
5
0134G–SEEPR–7/03
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
AT24C01B-TSU-T IC EEPROM 1KBIT 1MHZ SOT23-5
AT24C02C-XHM-B IC EEPROM 2KBIT 1MHZ 8TSSOP
AT24C04AN-10SI-2.7 IC EEPROM 4KBIT 400KHZ 8SOIC
AT24C08B-PU IC EEPROM 8KBIT 1MHZ 8DIP
AT24C1024B-TH25-B IC EEPROM 1MBIT 1MHZ 8TSSOP
AT24C1024Y4-10YU-2.7 IC EEPROM 1MBIT 1MHZ 8SAP
AT24C11Y1-10YU-1.8 IC EEPROM 1KBIT 1MHZ 8MAP
AT24C128BY6-YH-T IC EEPROM 128KBIT 1MHZ 8DFN
相关代理商/技术参数
AT24C01-10SI-2.5 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:2-Wire Serial EEPROM
AT24C01-10SI-2.7 功能描述:电可擦除可编程只读存储器 1K 128x8 1.2/2.7v RoHS:否 制造商:Atmel 存储容量:2 Kbit 组织:256 B x 8 数据保留:100 yr 最大时钟频率:1000 KHz 最大工作电流:6 uA 工作电源电压:1.7 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8
AT24C01-10SU-2.7 制造商:Atmel Corporation 功能描述:
AT24C01-10TC 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:2-Wire Serial EEPROM
AT24C01-10TC-1.8 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:2-Wire Serial EEPROM
AT24C01-10TC-2.5 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:2-Wire Serial EEPROM
AT24C01-10TC-2.7 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:2-Wire Serial EEPROM
AT24C01-10TI 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:2-Wire Serial EEPROM